MIL-PRF-3098/79F
TABLE I. Frequency response.
Frequency range,
Maximum
inclusive
resistance
kHz
Ohms
20 ppm
200 to 339
15 ppm
339+ to 484.999
10 ppm
485 to 580
1/ Crystal units in the frequency range 485 through
580 kHz (frequency tolerance 10 PPM) shall be
identified by a blue lacquer dot approximately
.125 inch (3.18 mm) diameter. It shall be located
on top of the can to the right of the letters "kHz."
TABLE II. Bond strength.
Frequency range,
Grams, minimum
inclusive (kHz)
200 to 250
700
250+ to 320
500
320+ to 370
400
370+ to 435
300
435+ to 580
250
Reference documents. In addition to MIL-PRF-3098, this document references the following:
The margins of this specification are marked with vertical lines to indicate where changes from the
previous issue were made. This was done as a convenience only and the Government assumes no
liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to
evaluate the requirements of this document based on the entire content irrespective of the marginal
notations and relationship to the last previous issue.
Custodians:
Preparing activity:
Army - CR
DLA - CC
Navy - EC
Air Force - 99
(Project 5955-2009-008)
DLA - CC
Review activities:
Air Force - 19, 84
NOTE: The activities listed above were interested in this document as of the date of this document.
Since organizations and responsibilities can change, you should verify the currency of the information
above using the ASSIST Online database at https://assist.daps.dla.mil/.
4
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business